TECHNOLOGY

ECO Cleaning Systems' advanced surface washing designs are integrated, closed loop systems, providing a variety of options to the cleaning industry. All ECS products operate up to 4000 PSI at 5 gallons per minute and are manufactured in Port Clinton, Ohio from American made components.

HydroRecyClean
This fully integrated, automatic, closed-loop system uses a proprietary six step filtration process to purify recovered water down to one micron, at 5 or 10 gallons a minute. With the HydroRecyClean system, operators can simultaneously clean surfaces while water is recovered and filtered, without the hassles of manual steps or multiple pieces of equipment. In addition, the HydroRecyClean system captures hydrocarbons, heavy metals and other hazardous chemicals and transforms them into non-leachable substances- the vast majority of which meet EPA guidelines for acceptable disposal. Each HydroRecyClean model can be diesel or electric powered, and are skid mounted, with the option of hot water. HydroRecyClean systems support up to two people cleaning any combination of: house/building, hood/duct, hard surface/carpet, vehicle/truck/trailer/rv/boat or airplane, simultaneously.

HydroRecycle
This diesel or electric driven, skid mounted machine is a stand alone unit for the recovery and filtration of contaminated wastewater, from up to four hundred feet away,. Available in 5 and 10 gallons per minute recovery, the HydroRecycle system employs the ECO Cleaning Systems six step filtration process to purify recovered water down to one micron. The HydroRecycle system captures hydrocarbons, heavy metals and other hazardous chemicals and transforms them into non-leachable substances, the vast majority of which meet EPA guidelines for acceptable disposal.

HydroVaccum
This stand alone unit, the HydroVacuum system recovers contaminated wastewater on site, at either 5 and 10 gallons per minute. This unit fulfills basic compliance with the US Clean Water Act. The HydroVacuum system recovers the dirty/gray water at up to ten gallons per minute, from up to four hundred foot away, thus preventing contaminants from entering a sewer system when setup properly. The HydroVacuum systems standard with a two stage filtration system is included, to remove gross contaminants to 3/32 of an inch in diameter and hydrocarbons, which are solidified for proper disposal. In addition, an optional pump-out system is available to pump recovered wastewater to a secondary holding tank or to a sanitary drain system when applicable.

HydroWhirl
This unit employs a whirly head with a vaccum attachment for the recovery of contaminated wastewater. The HydroWhirl system is available in 5 and 10 gallons per minute sizes.

HydroClean
These 'industrial' systems are designed to run all day, every day with minimal maintenance or upkeep. The key to the HydroClean systems is an industrial timing belt drive that rarely if ever needs adjustment or wears out, and never slips. The control of the HydroClean systems include engine and pump safety systems. These pressure washing systems are skid mounted or portable; diesel or electric, and available in both 5 and 10 gallon per minute sizes, with the option of hot water.

HydroRemote
ECS manufactures remote controlled chemical systems available for single or multiple chemical use. The HydroRemote systems are trigger-gun activated, can be used with up-stream or down-stream injectors, and are available in 12 & 24 VDC as well as 120 & 240 VAC input.